For the past few months, my vents on my truck would only blow air out of the floor and dash. No air would come out of the face vents. As many of you know, I try to encourage folks to work on their own car. Don't get me wrong, if it's too big of a job.. take it to the pros! But, if you can save some money by doing a little homework, why not save some money!
Last night, I investigated the problem online. I discovered that it may be a vacuum line problem. I went outside and looked for the little tubes that come from the top of the engine and look what I found... A dry-rotted line that was split right open! Voila!
So I thought, how hard can it really be to change some tubes! I went to the auto repair shop of my choice and purchased 4 feet of line to change all three. If I'm going to change one, I better go ahead and change three. All of them looked rough! So, one at a time, I cut one off... and replaced it with a new one.
I had a hard time squeezing the new line on some of the fittings, so I used some Liquid wrench on them. Went right on!
The new vacuum lines were on and looked good! Shortly after, I went for a test ride and was amazed.
Not only were my face vents blowing harder than ever, the truck ran better! The idle was smoother and I believe I gained horsepower. Maybe it is my imagination, but I doubt it.
0 comments:
Post a Comment